Check Valve Before Gate Valve

Check valves are used in a wide variety of locations but the focus of the discussion in this tutorial will be the installation of check valves at the steam trap outlet side.

Check valve before gate valve.

There are various types of check valves used in a wide variety of. Check valves are two port valves meaning they have two openings in the body one for fluid to enter and the other for fluid to leave. Generally both a check valve and a gate valve are installed in the discharge line. When the valve is wide open the gate is fully drawn into the valve bonnet.

From the 2016 edition of nfpa 13. When multiple water supplies serve the same fire sprinkler system each must have a check valve. 5 gate globe check valves gate valves design standards test inspection methods acceptance criteria test inspectionbolted bonnet gate valve api 600 iso 10434 asme b16 34 pressure seal gate valve long short pattern visual inspectionasme b16 34 api 603 gate valve api 603 api 6dthrough conduit gate valve. A check valve clack valve non return valve reflux valve retention valve or one way valve is a valve that normally allows fluid liquid or gas to flow through it in only one direction.

But years ago well before the development of ball. A check valve is a type of valve that allows fluids to flow in one direction but closes automatically to prevent flow in the opposite direction backflow. The type and method of testing conforms to one or more of many different standards. Ball valves are reliable and easy to use.

Gate valves are used when a straight line flow of fluid and minimum flow restriction are needed. How does a check valve for fire protection prevent contamination of potable water. Gate valves use a sliding plate within the valve body to stop limit or permit full flow of fluids through the valve. 8 16 1 1 3 1 where there is more than one source of water supply a check valve shall be installed in each connection.

The purpose of these tests and the expected results are often misunderstood and misapplied resulting in unnecessary delays and unanticipated costs. Bloch and budris 2004 gate valve should not be between check valve and pump. The conical wedge design and angular sealing devices of a metal seated wedge require a depression in the valve bottom to ensure a tight closure. The check valve is placed between the pump and the gate valve and protects the pump against reverse flow in the event of unexpected driver failure pump user s handbook.

Before the resilient seated gate valve was introduced to the market gate valves with a metal seated wedge were widely used. Normally valves are pressure tested by the factory to check for leaks before they re shipped.